5.0.5 = SCO OpenServer 5.0.5
5.0.6a = SCO OpenServer 5.0.6a
5.0.7 = SCO OpenServer 5.0.7
6 = SCO OpenServer 6
7.1 = SCO UnixWare 7.1
7.1.1 = SCO UnixWare 7.1.1
7.1.3 = SCO UnixWare 7.1.3
7.1.4 = SCO UnixWare 7.1.4
8 = SCO OpenUNIX 8
"Supported" indicates that an operating system has been successfully tested on the server and drivers are available.
(1) This server is available only in Asia Pacific and selected European regions and therefore is
only supported in these regions
(2) SCO OpenServer 5.0.7 support and certifications for the ML110 G2 SCSI model is limited to the
64-Bit/133-MHz Single Channel Ultra320 SCSI HBA G2. SCSI RAID controller is not supported.
(3) SCO OpenServer 6 support and certifications for the ML110 G2 SCSI model is limited to the
64-Bit/133-MHz Single Channel Ultra320 SCSI HBA G2. SCSI RAID controller is not supported.
The 64-Bit/133MHz Single Channel Ultra320 SCSI HBA G2 requires the mpt driver available
on the SCO OpenServer 6 media
The embedded Intel 82541PI PCI Gigabit NIC requires the e1008g driver available on the
SCO OpenServer 6 media
(4) SCO OpenServer 5.0.7 support and certification on ML150 G3 is limited to “HP 8 Internal Port SAS
Host Bus Adapter with RAID” controller. Use “lsil” driver available in HP ProLiant Extended Feature
Supplement for SCO OpenServer 5, ver. 5.790a.
(5) SCO OpenServer 6.0.0 support and certification on ML150 G3 with Embedded SATA is limited
to the ahci mode and the ahci driver updates for SCO OpenServer 6.0.0 are available from the
SCO website
|
Printable version
